en · de · es · fr · pt
epitalon-notes.peptides1004.com › Guide › Epitalon Background And Discovery — Beginner to Advanced

Epitalon Background And Discovery — Beginner to Advanced

By Editorial Desk · published 2025-08-08 · last reviewed 2025-08-24 · Guide

mass spectrometry comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.

Last reviewed on 2025-08-24. Where a claim depends on a specific study, the study is described rather than over-claimed.

Epitalon Background and Discovery

Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.

The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.

Laboratory Handling and Analytical Verification

Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.

Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.

Identity is normally established by reversed-phase high-performance liquid chromatography combined with mass spectrometry, a pairing that separates components and confirms molecular mass at once. Purity is quoted as a percentage from the chromatogram, and figures above ninety-five percent are a frequent commercial specification. Amino acid analysis or sequencing supplies further confirmation when required. Because many short peptides behave similarly under chromatography, retention time alone does not establish sequence; the mass measurement is what separates one tetrapeptide from another, and certificates should report both.

Epitalon at a glance

PropertyValueNotes
Molecular formulaC14H22N4O9Derived from the four-residue sequence
Molar massAbout 390.35 g/molFree peptide, counter-ion not included
AppearanceWhite to off-white powderLyophilised solid from aqueous solution
Water solubilityFreely solubleShort, polar peptide chain
Common synonymsAEDG; epithaloneCatalogues use the names interchangeably

Epitalon Background and Nomenclature

Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.

The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.

Related pages on this site

Handling, Storage and Analytical Checks

Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.

Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.

Structure, Naming and Discovery

Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.

The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.

Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.

Stability Handling and Quality Control

Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.

Reversed-phase high-performance liquid chromatography is the standard approach for assessing purity, usually with ultraviolet detection near 214 nm, where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the molecular mass and helps reveal truncation or deletion byproducts. Amino acid analysis can verify composition, and counterion content is sometimes measured because peptides purified with trifluoroacetic acid retain variable amounts of that salt. Purity figures reported without a stated method and detection wavelength are difficult to interpret.

Material sold for research use varies widely in documented quality. A useful verification package includes a certificate of analysis that states peptide content rather than only net weight, the chromatographic method and column used, and a mass spectrum consistent with the expected mass. Independent testing by a third-party laboratory is occasionally reported. Statements of identity resting only on a supplier label provide little assurance, and the gap between nominal mass and actual peptide content can be substantial once counterions and residual water are counted.

Supporting material

To address these challenges, the Pittsburgh Model of Function deconstructs 'function' into five meanings to describe the different properties that are acquired by a locus undergoing de novo gene birth: Expression, Capacities, Interactions, Physiological Implications, and Evolutionary Implications. It is generally accepted that a genuine de novo gene is expressed in at least some context, allowing selection to operate, and many studies use evidence of expression as an inclusion criterion in defining de novo genes. The expression of sequences at the mRNA level may be confirmed individually through techniques such as quantitative PCR, or globally through RNA sequencing (RNA-seq). Similarly, expression at the protein level can be determined with high confidence for individual proteins using techniques such as mass spectrometry or western blotting, while ribosome profiling (Ribo-seq) provides a global survey of translation in a given sample. Ideally, to confirm a gene arose de novo, a lack of expression of the syntenic region of outgroup species would also be demonstrated. Genetic approaches to detect a specific phenotype or change in fitness upon disruption of a particular sequence, are useful to infer function. Other experimental approaches, including screens for protein-protein and/or genetic interactions, may also be employed to confirm a biological effect for a particular de novo ORF. Evolutionary approaches may be employed to infer the existence of a molecular function from computationally derived signatures of selection.

=== Types of surgical incision === To realise the emplacement of a prosthetic breast (saline-solution or silicone-gel) into the implant-pocket of the woman patient, plastic surgeons employ five types of surgical incision:

Injury: A mild form of myositis can occur with hard exercise. A more severe form of muscle injury, called rhabdomyolysis, is also associated with myositis. This is a condition where an injury to the patient's muscles causes them to quickly break down. Medicines: A variety of different medicines can cause myositis. One of the most common types of drugs that can cause myositis are statins, which are used to lower cholesterol levels. One of the most common side effects of statin therapy is muscle pain which, more rarely, can lead to myositis. Infection: The most common infectious cause of myositis is viral infections, such as the common cold. Other viruses, such as COVID-19, are also shown to be a rare cause of myositis. Benign acute childhood myositis has been described in children after prodromal viral infections with different viral agents. Bacterial, parasitic, and fungal infections are other infectious causes of myositis. Inherited muscle disease: Many inherited myopathies may have secondary myositis, including calpainopathy, dysferlinopathy, facioscapulohumeral muscular dystrophy, dystrophinopathy, and LMNA-associated myopathy. Autoimmune: Autoimmune disease is an abnormal immune response to specific body protein or other biomolecular target, such as one of the muscles. The three main types of idiopathic myositis (known as inflammatory myopathies) that typically test positive for autoantibodies are dermatomyositis, polymyositis, and inclusion body myositis. Other autoimmune diseases, such as systemic lupus erythematosus, can also cause myositis-like symptoms.

Sources: en.wikipedia.org

Notes from published material

=== Energy sources === Kardashev's classification is based on the hypothesis that an advanced civilization uses significant energy, which implies that it must be de facto detectable over long distances, as summarized by Zoltan Galántai. For Kardashev, the limit of a civilization's energy consumption is originally located in the region of the electromagnetic spectrum from 106 to 108 Hz, which allows two observations related to thermodynamics. First, all the energy consumed is inevitably converted into heat. Second, this energy can only be dissipated in the form of radiation scattered in space. These two findings are the pillars of Kardashev's theory that cosmic objects with strong radiation could be artificial sources. He also considered the possibility of detecting an artificial source by emphasizing the spectral line of hydrogen in its use for nuclear fusion. Dutil and Dumas consider several physical limits to continuous energy production, such as photosynthesis (about 10 TW), climate (about 127 TW), and solar flux (174,000 TW). The only inexhaustible source of energy that can sustain a civilization for over several billion years, is deuterium (used in nuclear fusion). The sustainability of a civilization must therefore involve "strict control of the exploitation of available resources"; this difficulty in exceeding energy limits may explain the fact that the vast majority of civilizations fail to engage in a space colonization project.

== Prevalence == While the heritability of hypermobility is strong, specific genes implicated in the condition have not been identified. Prevalence of HSD alone is unknown, though previous estimates have placed the combined prevalence of hEDS and HSD between 194.2 per 100 000 (0.19%) or 1 in 500 people. Other studies have suggested that it affects around 3% of the UK population. The condition is relatively common in those attending musculoskeletal clinics.

=== Histology === In staining during microscopic examination for diagnosis or research, acid dyes are used to color basic tissue proteins. In contrast, basic dyes are used to stain cell nuclei and some other acidic components of tissues. Regarding cellular structures, acid dyes will stain acidophilic structures that have a net positive charge due to the fact that they have a negatively charged chromophore. Acidophilic structures include the cytoplasm, collagen and mitochondria. The two have an affinity for each other due to the conflicting charges. Examples of acid dyes used in medicine include:

Sources: en.wikipedia.org

Frequently asked questions

What is epitalon made of?

It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.

Why is it called epitalon?

The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.

Is epitalon approved for medical use?

No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.

How is epitalon identified in a laboratory?

Reversed-phase high-performance liquid chromatography is run alongside mass spectrometry. The chromatogram separates components and gives a purity figure, while the mass spectrum confirms that the measured molecular mass matches the expected sequence. Neither measurement on its own is treated as sufficient.

Network